On this episode of Onboard Lifestyle, Teal puts some finishing touches on our Master head and the girls get to move their stuff in. Check us out next week wh...

Closed Captions (CC):
[Music]

[Applause]

so now that the base cabinets are

finished I've described them to the

walls everything's nice and clean I'm

happy with it I took the interiors and

eyeglass everything on the inside first

so it keeps me from having to do it

later

so eyeglass and put a 6-ounce cloth on

the interior epoxy did it all in and

then installed the cabinet's permanently

epoxy them to the walls and did my

little radius trick put the 1 inch

radius of thickened epoxy to the hull

and then layered the entire base

cabinets with a 6 ounce cloth and

blended all that glass cloth into the

hall the floor and the walls it made

those permanently attached and there in

forget ok so the next thing I had to do

was build this little mini curve around

the perimeter of this room and I do that

by cutting Baltic mat into three quarter

inch strips and I'll have to pre cut any

corners or radius work before I soaked

it in epoxy I'll saturate it 100% let us

up for about two three minutes and then

stick it right to the ground probably

about two inches off of each surface

after its fired off I sanded smooth

radius the back edge Ferit smooth prime

it and paint it and why I put the curb

up is it gives the vinyl flooring you

know you've got your curb and it gives

your vinyl flooring something to go up

again so you don't have that rigid

transition when you're trying to get a

flat piece of vinyl up the wall or

around a cabinet and the system I have

done throughout the vessel and it works

pretty slick so I'm gonna keep going

with it I've only got a few more rooms

left and there you go ok so now that the

entire room is covered in glass cloth

and epoxy I'll let it cure for a couple

days and then it's time to start all the

cutouts I want to cut out as much as I

can at this point to give me access for

the next step so I cut out all my

electrical I cut out the sinks I cut out

all the cabinet door

I cut out lights everything I could just

I cut out of there and why I want to cut

at this point is because it's time to

start fairing this room out and the more

I cut out the more access I have to

behind the scenes so ou take an

ultra-light fairing compound and just

skim coat this room and just start

sanding sand it out to make it layer a

little bit more fair and compound sanded

out just kind of repeat and repeat and

repeat this whole process for this size

room took me about 16 hours to get the

fairing down about another six or eight

hours to sand it out and I just kept

kept going until I reach the desired

surface that I like and once you're

happy with it that's where the the fun

part comes the priming and the painting

because now your projects starting to

come together

somewhat

let's see what teal is doing right now

okay

see how far he's gotten painting master

head hello are you all master I would

help but we only have one mask so you

know but I'm a good participant right

good I'm thinking it looks good so how

many coats okay

I approve next up we're gonna be doing

the lighting Oh pulling them two sinks

counters toilet it's gonna be a fun

project once it's done I'm gonna really

enjoy the heck out of this room putting

all my fun stuff in here I can't wait to

decorate I want to start nesting Kevin

hi it's coming

is it changing what do you think okay so

if they do look like toilets don't they

except for you better not use that as a

toilet you're silly

okay so you're gonna help me run some

wires in a minute okay okay sounds good

that's gonna be one of the lights up

there

see these four lights with the wire

those and we're gonna put a switch

outlet right here a switch in the outlet

that's your my job today you got it yep

should fit right in there perfect I know

well we'll put the password now we'll

put little screws in just glue it in now

okay sounds good can you help me run

some wire okay

okay what we're gonna do I'm gonna go

down and the head let me open this up

take the 18 to right here and I want you

to stuff it through this hole right here

so unroll it put it up here and then

feed it through till I get it on the

other side okay okay start going okay

okay right there perfect okay now take

the 16 3 yep and this see this big hole

right here start stuffing it down there

until I could get it

okay perfect

okay thank you

now holster you are a Philly kid making

dinner

hey am I still need help get back over

here okay cut this off right here right

there

really hard use your muscles

perfect okay now take this again and put

it down there until I get put in the

rest yeah so you might have to strain it

out a little bit okay okay start going

is it going or is this getting stuck

okay try it again okay here swap me I'll

go to the top you go on the bottom you

tell me when it comes through

[Music]

[Music]

can't keep pulling pull a little bit out

just keep pulling yep

okay that's enough thank you can't leave

it right there

[Music]

[Music]

okay hand me the butt connectors oh no

not yet let's connect this answer

[Music]

[Music]

[Music]

[Music]

what do you think am I done

[Music]

now we're gonna see is it work it work

now we have lunch I got down to the head

again or / bathroom but this is

everything as you can see my dad is

putting in the toilet it's a ratchet

it's called a ratchet and these are

sockets and those are sockets right

pretty damn are you ready to use this it

that's an extension this is an extension

no idea what a torii yet I'm not saying

you can put it on here like this to make

this longer oh it isn't it extends it

see ya extension gonna fit which is

anywhere

yep there you go

[Music]

[Music]

okay so Till's just finishing up the

doors in our head and then I get to put

in there okay so here's what I've done

put your little stainless detail on the

front looks nice thanks

and your new cabinetry doors look at

this level in centimeters on those I

love it there's the other one

countertop is just has a black epoxy

pigment going right now we stopped to do

the granite work on this we'll save that

for a little bit nicer weather okay oh

here's something fun done here what do

you think these are for Michelle yeah

here's how it works

got your fancy little shell here just

snaps on looks good it snaps off snap on

snap off yep okay back to work okay so

then I get to I get a fills up right

yeah pretty soon let me just do a couple

more things you can start your process

put a couple of cleats here so you can

hang a couple hand towels and then that

is heating put put a heating duct in

here so yeah so we're getting there

after that then we'll probably put on

the water yeah I'll I'll wait a little

bit till we get the granite dam and then

I'll cut in the the faucets and hook up

the drains but we're getting close I

love it

[Music]

thanks for watching this episode of

onboard lifestyle and remember to leave

a like and be sure to subscribe

tune in next week when my dad starts

working on the guest stateroom see you

then